(sorry for cross post also sent this to the mailing list but noticed no activity in over a month... hoping this forum is a bit more frequented)
I purchased the LEDS Pro kit and I'm trying to figure out how to solder the conductive wire to the board. The solder just doesn't hold. Any help, clues, places to RTFM?
BlinkenLEDS pro documentation? (EN)
The mailing list is not that inactive - You must have found the archives of the old one...
I'll also give a short answer here, for the case anybody else wants to know:
There is a little error on this board, the solder pads for the wire got covered with solder stop. You'll have to scratch off the solder stop from the pads to make soldering possible.
I'll also give a short answer here, for the case anybody else wants to know:
There is a little error on this board, the solder pads for the wire got covered with solder stop. You'll have to scratch off the solder stop from the pads to make soldering possible.